ECT 122 WEEK 6 ILAB 2
ECT 122
Week 6 iLab 2
1.Determine
the range of output voltages for the circuit below. RLvaries from 47 Ω to 470 Ω.
2.Download
the Multisim file “Ser_Par4” from Doc Sharing, Week 6. Run the simulation and verify
that the simulated load voltage matches the calculated value.
3.
Construct the original circuit above on a breadboard. Connect the circuit’s
input to a variable positive supply. Connect the circuit’s input to the power
supply and set it to +10 V. Use a DMM to adjust the supply to +10 V. Measure
the load voltage with a DMM. Have the professor verify the
circuit before applying power.
No comments:
Post a Comment