ECT 122 WEEK 3 ILAB 1
ECT 122 Week 3 iLab 1
1.Identify
the type of the following circuits as either serial or parallel.
2.List
four characteristics of a series circuit.
3.Calculate
the total resistance in the circuit below. Show the formula used.
4.Download
the Multisim file “Series1” from Doc Sharing, Week 3. Run the simulation and
verify the simulated results are the same as the calculated values. Were the
values the same? Yes/No. If No, why?
5.Construct
the circuit above on the breadboard. Have the professor verify the circuit.
Using the handheld DMM and ELVIS DMM (if you are using ELVIS), measure each
resistor value and the total resistance. Record the values in the table below.
Compare the measurements and verify that they are within acceptable range.
No comments:
Post a Comment