ECT 122 WEEK 3 ILAB 3
ECT 122
Week 3 iLab 3
1.Using
the circuit below, calculate the anticipated voltage drops across each resistor
and record them below.
2.Download
the Multisim file “VD1” from Doc Sharing, Week 3. Run the simulation and record
the voltmeter readings.
3.Download
the Multisim file “Series3” from Doc Sharing, Week 3. Connect the potentiometer
as a variable resistor and set its initial value to 2.2 kW. Remember to set the
potentiometer before placing it in the circuit. Calculate the total current.
Simulate the circuit and record the values below.
4.Use the
breadboard to construct the circuit above. Verify that the value of
eachresistor is within tolerance. Remember that you should remove the resistor
from the circuit to obtain an accurate reading. Connect the input of the
circuit to the variable +12V supply connections on the workstation. If using
ELVIS, open the ELVIS Variable Power Supply in the Instrument Launcher. Set the
supply to +10 volts. Use the handheld DMM to verify that the input voltage is
+10 V. Measure and record each current listed below.Have the professor verify the connections before
applying power.
5.If
using ELVIS, use the ELVIS DMM to measure the current in the last circuit and
compare it to the readings obtained with the handheld DMM.
No comments:
Post a Comment