ECT 122 WEEK 5 ILAB 1
ECT 122
Week 5 iLab 1
Parts:
Breadboard
DC Power
Supply
Hand Held
DMM
Test
leads
Wire
100 Ω
resistor, 120 Ω resistor, 220 Ω resistor, 330 Ω
resistor
1.
Identify each of these circuits.
2. Given
the circuit below, calculate the values listed below.
3.
Download the Multisim file “Ser_Par1” from Doc Sharing, Week 5. Run the
simulation and verify that the simulated results are the same as the calculated
values. Were the values the same? Yes/No. If No, why not?
4.
Construct the circuit above on the ELVIS protoboard. Connect the circuit’s
input to the variable +12 V supply. Open the Instrument Launcher, start the
Variable Power Supply, and set it to +10V. Use the handheld DMM to adjust the
supply to +10 V. Using the handheld DMM, measure the values below. Remember
that to measure current, the DMM must be in series with the resistor. Have the professor verify the circuit before applying
power.
5. Repeat
step 4 using the ELVIS DMM instead of the handheld DMM. Remember to measure
current the DMM must be in series with the resistor. Have the
professor verify the circuit before applying power
No comments:
Post a Comment